Whole-home duct cleaning
Dryer vent cleaning
Camera inspection
Sanitizing & deodorizingWhole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Trusted Duct Repair & Sealing for Highland Park Homeowners
If your energy bill keeps climbing while the house never quite gets comfortable, leaking ductwork is often the culprit. Highland Park has a lot of older housing stock, and a lot of it runs on flex duct that’s been flexing in an attic for decades. When those joints split or the tape fails, you’re paying to condition air that never makes it to the room. We fix and seal the system at the source, then show you before-and-after photos of what changed. Our technicians have up to 8 years of experience working with Rotobrush and Nikro equipment, and we answer 24/7 at (844) 702-0753. Same-day repair is often possible across Highland Park.
What Our Duct Repair & Sealing Service Includes
We look at the whole air system, not one joint. That means pressure testing, tracing leaks, and confirming the fix actually holds before we close up the job. Each of the six repair categories below is part of the same idea: keep conditioned air inside the ducts where it belongs.
Duct Sealing
Sealing closes the gaps that let air escape before it reaches a register. You need it whenever a room feels weak while others blast, or when you can feel air moving in an attic crawl. We pressure-test the system, locate the leaks, and seal them with mastic and mesh rather than foil tape alone, which fails in the heat. Highland Park’s mild winters still bring attic temperatures that dry out adhesive over time, so we build the seal to last.

Flex Duct Repair
Flex duct is the corrugated plastic-and-wire duct that runs from the main trunk to individual registers. It kinks, tears, and sags, and any of those restricts airflow and invites contamination. You need a repair when a run has collapsed in a tight attic corner or been chewed through. We straighten, re-cut, and re-connect flex runs with proper support spacing so they don’t sag back into the problem.

Metal Duct Repair
Sheet-metal duct is durable but not indestructible. It separates at seams, corrodes at joints, and loses insulation wrap over the years. When a metal trunk leaks at a fitting, the pressure loss spreads to every branch downstream. We reseal seams, re-secure fittings, and repair wrap where it’s fallen away, restoring the trunk before touching the branches.

Duct Insulation
Insulation keeps the air inside the duct at the temperature it left the unit with. Bare or damaged duct in an attic loses that battle fast, and the room at the far end pays for it. You’ll notice it as warm air from the registers in summer or inconsistent heating through the house. We replace failed insulation wrap and re-cover exposed runs so the system holds temperature from unit to register.
Mastic Sealant
Mastic is the brush-on sealant professionals use at joints and seams. It’s the standard for a reason: it stays flexible, bonds to metal and flex alike, and doesn’t peel the way fabric tape does. You need it anywhere a joint has been taped and forgotten. We apply mastic at the plenum, trunk, and branch connections and check each coat before it sets.
Air Leak Repair
Air leaks are the sum total of every small gap in the system. You’ll spot them as dusty streaks around a register boot, a whistling sound at a fitting, or a room that never balances. Leaks at the boot where duct meets drywall are especially common in Highland Park’s older homes. We trace leaks with pressure testing and seal each one individually, then re-test to confirm the loss is gone.
Styles & brands we work with
- Whole-home duct cleaning
- Dryer vent cleaning
- Camera inspection
- Sanitizing & deodorizing
Brands We Service for Duct Repair & Sealing
We work with Guardsman and Rotobrush duct components and equipment, and we know where each brand tends to fail. Guardsman flex runs often need re-supporting in older attics where the straps have stretched. Rotobrush rotary tools let us agitate and inspect deep inside a run before we seal it, so we aren’t sealing over a problem we can’t see.
We also service Nikro HEPA extraction setups for the cleaning side of the job, since sealing a contaminated duct just traps the debris. If you’ve had a previous company clean your ducts and the results never showed, the equipment and method matter. Whether you have Guardsman or any other make, we can help.
Signs You Need Duct Repair & Sealing Right Now
- Rooms that never reach temperature. If one room stays cold while the rest of the house is comfortable, a leak or a collapsed flex run is the likeliest cause. It’s an airflow problem, not a thermostat problem.
- A dusty streak around a register. Dust accumulating at the edge of a ceiling register usually means air is escaping at the boot. That gap draws in attic dust and pushes it into the room.
- Whistling or hissing at the vents. Air noise at a fitting points to a restriction or an unsealed joint. It’s the system telling you pressure is escaping somewhere it shouldn’t.
- Energy bills that climb without a reason. When usage goes up but nothing about the house changed, lost conditioned air is worth checking. A pressure test confirms it quickly.
- Visible sagging or crushed duct in the attic. Flex runs that sag lose their round shape and choke airflow. If you can see a crushed run, the room it serves is being starved.
Our Duct Repair & Sealing Process – Step by Step
- 1
Whole-system inspection. We walk the full duct layout, from the unit and plenum to each register, and note every suspect joint, sag, tear, or failed wrap. Nothing gets sealed until we’ve mapped the system.
- 2
Pressure testing and leak tracing. We test the system to find where it’s actually losing pressure, rather than guessing. This tells us which leaks matter and which are minor, so the repair budget goes where it counts.
- 3
Cleaning before sealing. Using Rotobrush rotary tools and Nikro HEPA extraction, we clear loose debris from the runs we’re about to repair. Sealing over dirty duct traps the contamination inside for good.
- 4
Repair and seal. We re-support sagging flex, reseat metal fittings, re-wrap insulation, and apply mastic at every joint and seam. Each repair is checked as it’s done.
- 5
Re-test and photo report. We pressure-test again to confirm the loss is fixed, then share before-and-after photos of your actual ducts. You see the repair, not just a description of it.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Duct Repair & Sealing Cost in Highland Park?
Duct sealing in Highland Park typically runs $350 to $900 for a whole-home job, depending on how many leaks we find and how accessible the ducts are. A single flex duct repair usually lands between $150 and $400, since it’s one run and a straightforward reconnect. Replacing failed insulation wrap on exposed attic runs is commonly $250 to $700. Metal duct repair at a trunk or plenum sits in the $200 to $600 range, since seam work and fitting reseating take more time than a flex fix.
Several things move the price: whether the duct is in an attic, a crawlspace, or a wall, how many separate leaks need sealing, and whether a previous repair left tape or foam we have to remove first. Two-story homes with long branch runs cost more than a compact single-story layout. The way to avoid overpaying is to get a written, itemized estimate before any work starts and confirm what’s included, so you’re not discovering add-ons after the fact. Our estimate is free, and it covers the pressure test, the leak list, and the recommended repairs with a price for each. The written estimate sets the final price.
| Service | Typical Highland Park Range |
|---|---|
| Whole-home duct sealing | $350 – $900 |
| Single flex duct repair | $150 – $400 |
| Duct insulation replacement | $250 – $700 |
| Metal duct / plenum repair | $200 – $600 |
Duct Repair & Sealing Near Highland Park – Our Service Area
We connect homeowners across Highland Park and the surrounding neighborhoods with local pros who handle duct repair & sealing, duct repair & sealing, and duct repair & sealing across the area. That includes Eagle Rock, Glassell Park, Mount Washington, South Pasadena, El Sereno, Atwater Village, Alhambra, Pasadena, San Marino, Silver Lake, and San Pasqual. Fast dispatch runs from 7am to 7pm, Sunday through Friday, with same-day visits often available depending on the schedule. Call and we’ll confirm the soonest opening near you.
Serving Highland Park, CA – Our Local Coverage Area
We serve Highland Park and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Duct Repair & Sealing in Highland Park
Duct repair and sealing is the process of fixing physical damage to ductwork and closing the gaps that leak conditioned air. It covers torn flex duct, separated metal seams, failed insulation wrap, and unsealed joints at the plenum and registers. Where cleaning removes what’s already inside the duct, repair and sealing stops new contamination and air loss from getting in. It’s the part of the system most cleaners skip.
Most whole-home sealing jobs take a few hours to a full day, depending on how many leaks we find and how accessible the ductwork is. A single flex duct repair is usually done in under two hours. Attic access and long branch runs add time. Call (844) 702-0753 for an exact quote – estimates are free.
Typical pricing in Highland Park runs $350 to $900 for whole-home sealing, $150 to $400 for a single flex repair, and $200 to $600 for metal duct or plenum work. The final price depends on accessibility, the number of leaks, and whether old repairs need removal first. The written estimate sets the final price, with one flat price per job agreed before work starts. Call (844) 702-0753 for an exact quote – estimates are free.
Yes. We service Guardsman flex components and use Rotobrush rotary tools for inspection and debris agitation before sealing. If your ductwork uses either brand, we know where they tend to wear and what a proper repair looks like. Whether you have those brands or any other make, we can help.
Same-day repair is often available in Highland Park, depending on the schedule and the scope of the job. Fast dispatch runs from 7am to 7pm, Sunday through Friday, and we’re closed Saturday. We answer 24/7. A call outside dispatch hours is booked into the next opening, Sunday through Friday, 7am to 7pm.
We stand behind the work and back it with a satisfaction guarantee. That’s why we pressure-test again after sealing and share before-and-after photos of your actual ducts, so you can see the result rather than take our word for it. If something doesn’t hold, we want to know. Call and we’ll talk it through.
Clear access to the attic hatch, crawlspace entry, and any closet where the air handler sits. That’s the main prep. Remove fragile items near the access point and make sure someone is home to let the technician in. We handle the rest, including protection around the work area. You don’t need to move furniture for the inspection.
Schedule Your Duct Repair & Sealing Service in Highland Park Today
If your ducts are leaking, sagging, or just not delivering the comfort you’re paying for, we can help. Our team inspects the whole air system, explains what’s wrong in plain terms, and repairs and seals it with a flat price agreed before work starts. Call (844) 702-0753 for a free, no-obligation estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. You’ll see before-and-after photos of your own ducts.
Written by the team at Highland Park Air Duct Cleaning Pros.